英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • Need Help! DMU 50 setup help - CNCzone
    I'm absolutely new to the DMG Mori, DMU 50 Ours is 2015 year and has Siemens controls with the Celos Ergoline touchscreen control, 5 axis monoblock (n
  • M-Code List for PUMA Lathe - CNCzone
    The table below shows M-codes that apply for most PUMA models manufactured from year 1998 and up Gantry-loader models are not included in this list Actual availability of the M-codes as shown may vary, depending on machine type and optional equipment furnished
  • Gerber Sabre 408 - cnczone. com
    My old 408 will not start When I want to do the warm upp I get: !!!!!!!!!!!!!ERROR!!!!!!!!!!! SPINDLE I 0 FAILURE ATC works X,Y, Works Help e plz Nick
  • Newbie Inverted parts
    What do you mean "inverted"? Is it cutting out the parts mirrored from what the software shows? Did you draw them with Torchmate CAD? Are you using the correct tool path? (ie male for shapes female for holes)
  • Need Help! HAAS ST20 turret alignment procedure or service manual - CNCzone
    I have a ST-20 Lathe 2 75" AT 7 long tool steel stock came out of chuck while turning the od The machine now is leaving a 080 nub when facing
  • Thread Milling NPT threads - CNCzone
    Make the hole in the model the correct OD and taper for the finished thread Then if you set "Stock to Leave" to 0 000, the thread should come out exactly as you want, assuming your tool definitions are correct With thread-milling, you pretty much always have to do a test cut or two to exactly dial in the fit Regards, Ray L
  • Triangular Gantry Beam - cnczone. com
    The optimal gantry shape may be a triangle peteeng has posted some good information and simulations on triangular shaped gantry beams The real test i
  • UCCNC Laser plugin - how to connect? - CNCzone
    Hi - I use UCCNC for router work I want run a laser from UCCNC via its laser plugin I have a gecko G540 on one machine and a ST-6560V4 on another Bo
  • CNC Lathe - X AXIS losing POSITION - CNCzone
    If the turret is not traveling far enough then that would mean the the computer thinks that it got enough pulses to be in position, when it actually has not reached position and thus is seeing phantom pulses Since your maintenance staff have pretty much eliminated mechanical issues as a possibility, the most likely cause is electrical This can happen with a bad encoder, a loose connection
  • Editing Ladder on 18-T Control - cnczone. com
    Wouldn't you be better served by getting a factory ladder solution that would satisfy this safety requirement? I've been in a situation where there was an injury on the job and the ladder of the machine was taken into question If you're "fingerprints" were on the ladder and a safety issue is at hand there may be an opening for litigation





中文字典-英文字典  2005-2009